Nilfisk-Advance SC500 9087352020 Instructions For Use Manual

Nilfisk-Advance SC500 9087352020 Instructions For Use Manual Manual pdf 21 page image

INSTRUCTIONS FOR USE ENGLISH9099980000 - SC500 1911/2014BATTERY CHARGINGNOTECharge the batteries when there is only one flashing segment displayed in the battery symbol (51-C), or at the end of theshift.Keeping the batteries charged make their life last longer.CAUTION!When the batteries are discharged, charge them as soon as possible, as that condition makes their life shorter.Check for battery charge at least once a week.WARNING!When using lead (WET) batteries, battery charging produces highly explosive hydrogen gas. Charge thebatteries in well-ventilated areas and away from naked flames.Do not smoke while charging the batteries.Keep the recovery tank raised until the battery charging cycle is over.WARNING!Pay close attention when charging WET CELL batteries, as there may be battery fluid leakages. The battery fluidis corrosive. If it comes in contact with skin or eyes, rinse thoroughly with water and consult a physician.1. Drive the machine to the appointed recharging area.2. Ensure that the machine is off and the operator key (41) has been removed.3. Lift the cover (34) and check that the recovery tank (33) is empty; if not, empty it using the drain hose (12).4. Close the cover (19).5. Grasp the handle (16) and carefully lift the tank (33).6. (For WET CELL batteries only) Check the level of electrolyte inside the batteries. If necessary, unscrew the caps and top up.When the correct level is restored, close the caps and clean the tops of the batteries.7. Plug the battery charger (6) into the mains electricity supply (the mains voltage and frequency must be compatible with thebattery charger values shown on the machine serial number plate).NOTEWhen the battery charger is connected to the electrical mains, all machine functions are automatically cut off.When the first or second segment from the left in the battery symbol (51-L) is flashing, this means that the battery charger ischarging the batteries.When the third segment from the left in the battery symbol (51-L) is flashing, this means that the battery charger is finishing thebattery charging cycle.8. When all segments of the battery symbol (51-L) are steadily lit, the battery charging cycle is complete.9. Disconnect the battery charger plug (6) from the mains and place it in its holder (7).10. Carefully lower the recovery tank (33).11. Now the machine is ready to be used.NOTEFor further information about the operation of the battery charger (5), see the relevant Manual.https://harrissupplyind.com - To Order Parts Call 608-268-8080