ENGLISH INSTRUCTIONS FOR USE22 SC500 - 909998000011/2014SQUEEGEE CLEANINGNOTEThe squeegee must be clean and its blades must be in good conditions in order to get a good drying.CAUTION!It is advisable to wear protective gloves when cleaning the squeegee because there may be sharp debris.1. Drive the machine on a level floor.2. Ensure that the machine is off and the operator key (41) has been removed.3. Loosen the handwheels (14) and remove the squeegee (29).4. Wash and clean the squeegee. In particular, clean the compartments (A, Fig. 11) and the vacuum hole (B). Check the conditionof the front (C) and rear (D) blades, ensuring there are no cuts and tears; if necessary, replace them as shown below.5. Install the squeegee in the reverse order of removal.SQUEEGEE BLADE CHECK AND REPLACEMENT1. Clean the squeegee as shown in the previous paragraph.2. Check the condition of the front (C, Fig. 11) and rear (D) blades, ensuring there are no cuts and tears; if necessary, replacethem as shown below. Check that the front corner (E) of the rear blade is not worn; otherwise, turn the blade to replace theworn corner with one of the three remaining intact corners. If the other corners are worn too, replace the blade according to thefollowing procedure:• Using the tab (F), release and remove the elastic strap (G) from the fasteners (H), then turn or replace the rear blade (D).• Install the blade in the reverse order of removal.• Unscrew the handwheels (I) and remove the strap (J), then turn or replace the front blade (C).• Install the blade in the reverse order of removal.3. Install the squeegee (27) and screw down the handwheels (14).4. Lower the squeegee to the floor to check the height of the blades, proceeding as follows:• Check that the lip (K) of the front blade (C) and the lip (L) of the rear blade (D) are resting as shown in the figure.• Use the knob (15) to make adjustments.AIABDCGK E LDCJJHFGFIFigure 11P100850https://harrissupplyind.com - To Order Parts Call 608-268-8080