Nilfisk-Advance SC500 9087352020 Instructions For Use Manual

Nilfisk-Advance SC500 9087352020 Instructions For Use Manual Manual pdf 28 page image

ENGLISH INSTRUCTIONS FOR USE26 SC500 - 909998000011/2014FUSE CHECK/REPLACEMENTNOTEAll machine electrical circuits are protected by auto-resettable electronic devices. The safety fuses activates only in caseof serious damage.It is recommended to have the fuses replaced by qualified personnel only.Refer to the Service Manual available at any Advance Retailer.TROUBLESHOOTINGTROUBLE POSSIBLE CAUSE REMEDYThe motors are not operating; the display (51) andbutton LEDs do not turn on.The battery connector is disconnected. Connect.The batteries are completely discharged. Charge the batteries.The machine does not move and the display (51)shows the alarm:WARNING ALARM T3Machine turned on with paddle pressed. Release the paddle.If the problem persists, contact an authorisedService Center.At machine start-up, the button (43) LED flashesand the brushes do not work.Machine switched off without first raising thebrush deck.Wait for the deck to raise before turning thebrushes on again by pressing the switch.The brush does not operate; the battery symbol(51-C) border flashes and the display shows thealarm message:WARNING ALARM G4The batteries are discharged. Charge the batteries.If the problem persists, replace the batteries.When working, the display shows the alarmmessage: WARNING ALARM F2Brush motor overload. Use a different/less aggressive brush and/oravoid working with extra pressure turned on.There are foreign materials (tangled threads,etc.) preventing the brush from rotating.Clean the brush hub.The display (51) shows the alarm message:WARNING ALARM T2Drive motor overload. Turn off the machine and then turn it on again.Avoid using the machine on slopes greaterthan those indicated or going over excessivelytall obstacles.While recharging the batteries with the on-boardbattery charger, the display (51) shows the alarmmessage:WARNING ALARM C4 or C5Battery charger not able to correctly rechargethe batteries within the maximum time.Run the battery charging cycle again.If the problem persists, replace the batteries.The display (51) shows an alarm message of thefollowing type:WARNING ALARM XXWhere “XX” is a code other than those listedabove.The machine electronic control system is inalarm condition.Turn off the machine and then turn it on again.If the problem persists, contact an authorisedService Center.The dirty water vacuuming is insufficient. The recovery tank is full. Empty the tank.The vacuum grid is clogged or the float isstuck closed.Clean the vacuum grid.Debris collection filter container clogged. Clean.The hose is disconnected from the squeegee. Connect.The squeegee is dirty or the squeegee bladesare worn or damaged.Clean the squeegee or overturn/replace theblades.The tank cover is not properly closed, or thegasket is damaged.Correctly close the cover or clean/replace thegasket.The solution flow is insufficient. The washing water tank is empty. Refill.The washing water filter is dirty. Clean the filter.The EcoFlex™ system tank is dirty/encrusted. Clean with the drain cycle.The squeegee leaves marks on the floor. There is debris under the squeegee blades. Remove the debris.The squeegee blades are worn, chipped ortorn.Overturn or replace the blades.The squeegee has not been balanced with thehandwheel.Adjust the squeegee.NOTEThe machine is inoperative without the battery charger.In case of battery charger malfunction, contact an authorised Service Center.For any further information, contact Advance Service Centres.https://harrissupplyind.com - To Order Parts Call 608-268-8080