Messaging75E-mailSelect Messaging > Options > Settings > E-mail, or inthe mailbox main view, selectOptions > E-mail settings and from the following:Mailbox in use—Select which mailbox you want to use forsending e-mail.Mailboxes—Opens a list of mailboxes that have beendefined. If no mailboxes have been defined, you areprompted to do so. Select a mailbox to change thesettings:Mailbox settingsMailbox name—Enter a descriptive name for the mailbox.Access point in use (Must be defined)—Select an Internetaccess point (IAP) for the mailbox. See "Connectionsettings" on page 106.My e-mail address (Must be defined)—Enter the e-mailaddress given to you by your service provider. Replies toyour messages are sent to this address.Outgoing mail server (Must be defined)—Enter the IPaddress or host name of the mail server that sends youre-mail. You may only be able to use the outgoing server ofyour network operator. Contact your service provider formore details.Send message—Define how e-mail is sent from the device.Select Immediately for the device to connect to themailbox when you select Send message. Select Duringnext conn.—E-mail is sent when the connection to theremote mailbox is available.User name—Enter your user name, given to you by yourservice provider.Password—Enter your password. If you leave this fieldblank, you are prompted for the password when you try toconnect to your remote mailbox.Incoming mail server (Must be defined)—Enter the IPaddress or host name of the mail server that sends youre-mail.Mailbox type—Defines the e-mail protocol that yourremote mailbox service provider recommends. The optionsare POP3 and IMAP4. This setting can be selected onlyonce and cannot be changed if you have saved or exitedfrom the mailbox settings. If you are using the POP3protocol, e-mail messages are not updated automaticallyin online mode. To see the latest e-mail messages, youmust disconnect and make a new connection to yourmailbox.
