A c c e s s t h e I n t e r n e t31■ Connectivity settingsWhen you access an application that requires an Internet connection,you are asked to select the connection (Internet access point) you wantto use.In the Select connection dialog, select a connection from the list, andtap Connect. Only available connections are shown. The connection thatyou set as preferred appears at the top of the list. If you have not set thepreferred connection, the last used connection (if available) is shown first.To define the connectivity settings, tap , and select Control panel >Connectivity settings.In the General page, define the following settings:Preferred connection — To change the preferred connection, select aconnection from the list.Use without asking — If you select this option, the Internet access pointthat you selected in Preferred connection is used automatically whenyou start an application requiring an Internet connection. In this case,you do not need to confirm the connection.On the Idle times page, select the time after which the Internet connectionends automatically if the connection is not used. Use Packet data idle timefor packet-switched data connections (such as GPRS), Data call idle timefor circuit-switched data calls (such as GSM data), and WLAN idle time forconnections created through a wireless local area network (WLAN)access point.Note: Time-based charges may apply to the Internetconnections. Check with your service provider, and adjustthe idle times accordingly.Note: The network may also have idle timers that may causethe Internet connection to break, regardless of the idle timersof the device.To use a connection automatically, select Control panel > Connectivitysettings > General. Set the desired connection as Preferred connection,and select Use without asking.