GB 13Antenna with one LNB for SiriusWhen you select alternative 2 from the previous menu (above)and press OK you will get the “Antenna adjustment” menushown to the right.Three channels are preprogrammed. When you adjust the an-tenna towards Sirius these channels will be used to locate theSirius satellite.1 Select one of the preprogrammed channels. Adjust the an-tenna towards the Sirius satellite until the AGC * ) level get ashigh as possible. The level is indicated with the red bar at thetop of the menu.2 When the antenna is aimed at the satellite and the signal levelis as high as possible, press OK.Antenna/Satellite SelectionISelect the alternative on the first line when you have anantennaequipped with one (1) LNB and intend to receive channels fromthe Sirius satellite. To acheive best possible reception you shoulduse a Universal LNB.Select line 2 for other antenna and satellite combinations.FIRST TIME INSTALLATION3 The bar at the top of the menu will now change to a red/yel-low/green Signal Quality (SNR) * ) indicator for that specificchannel.If you have found a digital signal from Sirius the backgroundwill change and show a TV picture. It may take a few seconds be-fore the picture appears.If you do not get a picture, you may be tuned to an analogue sig-nal source. Another reason could also be that the antenna is po-sitioned towards the wrong satellite.If so, press the BACK button and start from point 1 again.(If you have a good indication in the signal quality menu, but nopicture from any of the channel alternatives, try proceeding withthe channel search anyway by pressing OK).When you have picture from a TV channel, press OK. The Media-master automatically starts searching for channels from the sat-ellite. When the search procedure is finished you will get a mes-sage telling how many TV- and radio channels have beed found.Please refer to page 16.* ) Information about AGC and SNR is found on the next page.OKOK