Nokia MEDIAMASTER 9780 S Owner's Manual

Also see for MEDIAMASTER 9780 S: Quick guide

Nokia MEDIAMASTER 9780 S Owner's Manual Manual pdf 35 page image

GB 35ProblemThe display on the front panel doesnot light up/is not lit.No sound or picture, but the frontpanel shows the time or - - : - -.No sound or picture.No sound or picture on horizontalmodulated transponder.Bad picture/blocking error.There is no Welcome menu on thescreen after you switched on theMediamaster for the first time.There is interference on your digitalsatellite channels, an existing ter-restrial channel or video signal.You made a video recording of a dig-ital satellite channel and whole orparts of the programme was notrecorded.Possible causesMains cable is not connected.The Mediamaster is in standbymode.The satellite dish is not pointingat the satellite.No signal or weak signal.The LNB is faulty.The satellite dish is not pointingat the satellite.Signal too strong.Satellite dish is too small.LNB noise factor too high.The LNB is faulty.The system is connected by SCARTleads and the TV is not in AV/EXTmode.The system is connected by RFleads and the TV is not set to thechannel tuned for digital satelliteTV.The system is connected by RFleads and the output channel of theMedia-master interferes with anexisting terrestrial channel or videosignal.The Mediamaster was not left onthe appropriate channel.The system is connected by SCARTleads and the VCR is not in AV/EXTmode.The system is connected by RFleads and the VCR is not set to thechannel tuned for digital satelliteTV.What to doCheck that the mains cable isplugged into the power socket.Press the standby button or anynumber button to bring the Media-master out of standby mode.Adjust the dish. Check the signallevel indicator in one of the channelsearch submenus.Check the cable connections, LNBand other equipment connected be-tween the LNB and the receiver, oradjust the dish.Replace the LNB.Increase the LNB voltage with 0,5 Vfrom the System Configurationmenu if you have a long cable.Adjust the dish.Connect a signal attenuator to theLNB input.Change to a larger dish.Change to an LNB with lower noisefactor.Change the LNB.If the system is connected bySCART leads, switch the TV to theappropriate AV input.If the system is connected by RFleads, switch the TV to the channelfor digital satellite TV. If you havenot tuned in the TV you may do thisfirst. Please look in the TV manualfor instructions. You can alsochange the RF-channel in theMediamaster. See TV settings.Change the Mediamaster outputchannel to a more suitable channelbetween 21-69, or connect the sys-tem by SCART leads.If you make a recording of digitalsatellite TV your Mediamaster hasto be left on the channel you wantto record.If the system is connected bySCART leads, switch the VCR toappropriate AV input.If the system is connected by RFleads, switch the VCR to the chan-nel for digital satellite TV. If youhave not tuned in the VCR you maydo this first. Please look in the VCRmanual for instructions.PROBLEM SOLVING