GB 8The box for your Mediamaster should contain thefollowing items:• the Mediamaster• a remote control with 2 AAA batteries• a SCART lead (fully featured 1,0 metre)• a mains lead• an aerial/RF lead (double screened 1,5 metres)• a cable to the telephone• an Owner’s Manual (this document)• a Software License agreement• a quick guideCONNECTION OF THE MEDIAMASTERAbout the SCART socketsThe rear panel of the Mediamaster is equipped with 2 SCARTsockets (see diagram). When you connect other products toany of these sockets, always use fully featured SCART leads(as supplied). There are “less well specified” SCART leads on themarket and picture quality could be reduced if you use them. SCART socketSCART leadOwner’s manualLicense agreementQuick guidePhonecableRF leadPreparing the Remote Control• Remove the cover on the battery compartment at the bottomof the remote control.• Insert the 2 AAA (1,5 V) batteries, as shown in the diagram,taking care to observe the + and - markings indicated inside.• Replace the cover.Installing the Satellite DishConnect the coaxial cable, with F-connectors fitted, from the LNBon the satellite dish to the socket marked ”ANTENNA”on the rearpanel of the Mediamaster.Connecting the Mediamaster to the DishIf you need to fit the F-connectors onto the cable• Prepare each end of the cable as shown in the diagram. Youwill need to fold back the outer braid (as shown).• Slide the F-connector onto the cable, then turn it clockwiseuntil it grips the braid.• Ensure that 3 mm of the core is protruding from the end of theconnector.8 mm15 mm3 mmF-connectorMainsleadRemotecontrol