Nokia MEDIAMASTER 9902 S Owner's Manual

Contents

Nokia MEDIAMASTER 9902 S Owner's Manual Manual pdf 19 page image

GB 19FIRST TIME INSTALLATIONManual searchWhen you perform a Manual search you first need to enter someparameters for the channel search to work.The information you need to enter in this menu is available inmagazines covering satellite TV reception, on the Internet or fromyour Service Provider.Transponder frequency: Specify the frequency in GHz. If youenter the wrong figure(s), erase with the button.Polarization: Select Horizontal, Vertical, Circular left or Circularright.Symbol rate (MSym/s): Enter with the numeric buttons. If youenter the wrong figure(s), erase with the button.FEC: Select “Auto” or any of the preprogrammed values.Network search: Select “Yes” if you want to search on all trans-ponders connected to a specific network.Adjust motor: Adjust (if necessary) the motor for the currentsatellite.Press OK to start searching for channels.Advanced searchThe information to enter in this menu is available in magazinescovering satellite TV reception, or from your Service Provider.You can use this menu if you are looking for some “special” chan-nels (i.e. non-DVB standard channels) which can only be foundwhen you have entered the necessary settings here.Transponder frequency: Specify the frequency in GHz.Polarization: Select Horizontal, Vertical, Circular left or right.Symbol rate (MSym/s): Enter with the numeric buttons.FEC: Enter the appropriate Forward Error Correction (FEC) orselect AUTOPID Video: Enter the PID (Packet Identifier) for the video signal.PID Audio: Enter the PID for the audio signal.PID PCR: Enter the PID for the PCR (Programme Clock Refer-ence).Adjust motor: Adjust (if necessary) the motor for the current sat-ellite.Press OK to start searching for channels.In case you have an antenna motor to control your satellite an-tenna you have to make the following settings. If your antennais prevented from reaching its east/west limit positions, you haveto set these limits. See page 47 for instructions.• From the “Antenna/Satellite selection” menu select line 7 andpress OK.• Select line 5, “Motor antenna” and press OK.Motor antenna