GB 15Language• Select the desired menu language with cursor up/cursordown.This will also become the main language for audio and subti-tling.• Press select to continue.General informationOnce you have correctly connected the Mediamaster, you alsohave to perform a “First time installation.” During this procedure,helpful information is displayed at the bottom of the menus.Please note!The select button always confirms a selection within thesemenus, and pressing it will take you to the next step in the instal-lation process. However, and this is important, often more thanone value has to be entered in a menu. First, perform all neces-sary settings on the different lines. Then, confirm them all simul-taneously by pressing select.You can always go back to the previous menu by pressing back.Use cursor up/cursor down to move upwards and downwardsfrom one line to another.Use cursor left/cursor right to change settings.You can also use the numeric buttons on the remote control toenter numeric values.FIRST TIME INSTALLATIONThe “First time installation” menuThis picture indicates that you have started the installation pro-cedure.• Plug in your Mediamaster.• The “First time installation” menu is shown.• Press select to continue.Antenna/satellite selection• Select alternative “One antenna/one LNB configuration” if youhave a single antenna equipped with one LNB for receiving sig-nals.• Select alternative “Multisatellite/DiSEqC switch configuration”if you have one antenna with two or four LNBs or two anten-nas with one or two LNBs each for receiving signals from acombination of satellites. In these cases you need a 2-way ora 4-way DiSEqC switch.• Select alternative “Motor antenna configuration” if you havean antenna motor to control your satellite antenna.