Nokia Mediamaster 210 Owner's Manual

Also see for Mediamaster 210: Owner's manual Manual

Nokia Mediamaster 210 Owner's Manual Manual pdf 19 page image

GB 19FIRST TIME INSTALLATIONChannel searchThe Channel search procedure can be performed in differentways.The menu will look different depending on what option you se-lected in the “Antenna/satellite selection” menu.If you selected “One antenna/one LNB configuration” you just se-lect “Automatic”, “Manual” or “Advanced Manual” search.If you selected “Multisatellite/DiSEqC switch configuration” or“Motor antenna configuration” you also have to set which satel-lite to search from, using cursor left/cursor right.Automatic searchIf you selected “One antenna/one LNB configuration” or“Multisatellite/DiSEqC switch configuration”:• Press select to start searching for channels.If you selected “Motor antenna configuration”:• Select predefined channel and then adjust the motor (if neces-sary) with cursor left/cursor right.• Press select to start searching for channels.Manual searchThe information you need to enter in this menu is available inmagazines covering satellite TV reception or on the Internet.Transponder frequency: Specify the frequency in MHz with thenumeric buttons. If you enter the wrong value, erase with cursorleft.Polarisation: Select Horizontal, Vertical, Circular left or Circularright.Symbol rate: Enter with the numeric buttons. If you enter thewrong value, erase with cursor left.Network search: Select “Yes” if you want to search on all trans-ponders connected to a specific network.Adjust motor: This alternative will only be visible if you have madea motor antenna configuration. Adjust (if necessary) the motor forthe current satellite.• Press select to start searching for channels.Video, Audio and PCR PIDThese alternatives will only be visible if you are searching from anuser defined satellite. By entering these values you can see TVpicture on the background which may help you in adjusting thedish.Remove limitsIn case you need to remove limits.When you perform this command the motor will also turn itselfto the 0° (Zero) position.However, next time you select a channel the motor will turn to itsproper position.