Settings114Sleep modeSelect Off to disable the power saver LED for the sleepmode.EnhancementEnhancement sett.For enhancement indicators, see ‘Essential indicators’,p. 14.The available settings depend on the type of enhancement.Select an enhancement and from the following:Default profile—Set the profile that you want activatedeach time you connect a certain compatible enhancementto your device. See ‘Profiles—set tones’, p. 82.Automatic answer—Set if you want the device to answeran incoming call automatically after 5 seconds. If theringing type is set to Beep once or Silent, automaticanswer is disabled.Lights—Set whether lights remain on, or are switched offafter the time-out. This setting is not available for allenhancements.If you are using a Text phone or a Loopset, you mustactivate it on your device. To activate Text phone, selectText phone > Use text phone > Yes. To activate theloopset, select Loopset > Use loopset > Yes.SecurityTo edit settings related to the security, press , andselect Tools > Settings > General > Security > Phoneand SIM card, Certificate management, or Securitymodule.Phone and SIM cardPIN code request—When active, the code is requestedeach time the device is switched on. Deactivating thepersonal identification number (PIN) code request may notbe allowed by some SIM cards.PIN code, PIN2 code, and Lock code—You can change thelock code, PIN code, and PIN2 code. These codes can onlyinclude the numbers from 0 to 9. If you forget any of thesecodes, contact your service provider. See ‘Glossary of PINand lock codes’, p. 115.Avoid using access codes similar to the emergencynumbers to prevent accidental dialing of the emergencynumber.Keypad autolock period—Select whether the keypad islocked when your device has been idle for a certain periodof time.