NordicTrack NTEL12910 User Manual

Also see for CXT 990: User manual User manual Manual Del Usuario Manuel de l'utilisateur Manuale d'istruzioni

Contents

76. Connect the wire harness on the Console (87) to theExtension Wire Harness (51).Attach the Console (87) to the Upright (2) with the fourConsole Screws (35) and the four Console Washers(93) packaged with the Console. Be careful to avoidpinching the wire harnesses.Snap the bookrack onto the Console (87) in the locationshown.6 87WireHarnessBookrack359393355127. Identify the Left Pedal (41). Attach the Left Pedal to theLeft Spring Arm (3) with an M10 x 36mm Carriage Bolt(61), an M10 Washer (63), and an Adjustment Knob(77) as shown. Note: The Left Pedal can be attached inany of five positions (see HOW TO ADJUST THE PED-ALS on page 9).Attach the Right Pedal (not shown) in the same way.Make sure that both Pedals are in the same position.78. Apply a small amount of the included Teflon® lubricantto a paper towel. Rub a thin film of the lubricant ontothe Chrome Tubes (21). Next, slide the Left UpperBody Arm (7), which is marked with a sticker, onto theleft Chrome Tube. Slide the Right Upper Body Arm (75)onto the right Chrome Tube. Make sure that theUpper Body Arms are on the correct sides—theupper ends should bend in the direction shown bythe arrows. Next, slide an Axle Cover (74) onto thepost on each Upper Body Arm.Apply grease to the Arm Axle (19). Insert the Arm Axleinto the right Axle Cover (74) and the Right Upper BodyArm (75). Next, insert the Arm Axle into the Upright (2)until the left end of the Arm Axle is flush with the leftside of the Upright. Then, insert the Arm Axle into theleft Axle Cover (74) and the Left Upper Body Arm (7).Center the Arm Axle (19). Using the included pedaltool, tap two Push Nuts (15) about 1/8” onto each endof the Arm Axle. Make sure that the Push Nuts areturned as shown in the inset drawing. (Note: It may behelpful if another person holds a block of wood againstone end of the Arm Axle while you tap Push Nuts ontothe other end.) Then, press an Axle Cap (34) onto eachend of the Arm Axle.89. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware maybe left over after assembly is completed.2121274PostGrease741934341515775Pedal Tool 15 19416337761