NordicTrack NTEL12910 User Manual

Also see for CXT 990: User manual User manual Manual Del Usuario Manuel de l'utilisateur Manuale d'istruzioni

Contents

8INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSORIf you purchase the optional chest pulse sensor (refer topage 19), follow the steps below to install the receiver andthe Y-connector included with the chest pulse sensor.1. Remove the four indicated screws from the back of theConsole (87). Lift the top of the Console. Be carefulnot to disconnect any wires.2. Peel the paper off the adhesive pad on the back of thereceiver (A). Orient the receiver exactly as shown, andpress it onto the Console (87) in the indicated location.Connect the wire on the receiver (A) to the Y-connector(B) as shown. Unplug the indicated console wire (C)from the indicated jack (D), and plug the console wireinto the Y-connector. Then, plug the Y-connector intothe jack (D).Refer to step 1 above. Reattach the top of the Console(87) with the four screws. Make sure that no wiresare pinched.Note: Any other wires that are included with the chestpulse sensor may be discarded. A87Screws1BCDCylinder287