Safety1-2 1998 Nordson CorporationAll rights reservedIssued 10/98S1EN−03−[SF−LECAP]−7To prevent injury follow these instructions. Do not operate or service equipment unless you are qualified. Do not operate equipment unless safety guards, doors, or covers areintact and automatic interlocks are operating properly. Do not bypassor disarm any safety devices. Keep clear of moving equipment. Before adjusting or servicingmoving equipment, shut off the power supply and wait until theequipment comes to a complete stop. Lock out power and secure theequipment to prevent unexpected movement. Relieve (bleed off) hydraulic and pneumatic pressure before adjustingor servicing pressurized systems or components. Disconnect, lockout, and tag switches before servicing electrical equipment. While operating manual spray guns, make sure you are grounded.Wear electrically conductive gloves or a grounding strap connected tothe gun handle or other true earth ground. Do not wear or carrymetallic objects such as jewelry or tools. If you receive even a slight electrical shock, shut down all electrical orelectrostatic equipment immediately. Do not restart the equipmentuntil the problem has been identified and corrected. Obtain and read Material Safety Data Sheets (MSDS) for all materialsused. Follow the manufacturer’s instructions for safe handling anduse of materials, and use recommended personal protection devices. Make sure the spray area is adequately ventilated. To prevent injury, be aware of less-obvious dangers in the workplacethat often cannot be completely eliminated, such as hot surfaces,sharp edges, energized electrical circuits, and moving parts thatcannot be enclosed or otherwise guarded for practical reasons.5. Personal Safety

Issued

Manual

Introduction

Personal Safety

High-Pressure Fluids

Fire Safety

Halogenated Hydrocarbon Solvent Hazards

Safety Labels

H Manual

Options

Typical Heated Circulating System

Theory of Operation

Installing the Cable to the AN-8 Plus Gun

Installing the Gun

Installing the Air Flow Switch, Hoses, and Fittings

Securing the Hoses and Gun

Checking the Gun After Installation

Installing a New Extension Resistor Kit and Cable

Daily

Gun Maintenance

Mechanical Problems

Electrostatic Problems

Disassembling the Gun

Internal Parts

Replacing the Extension Resistor Service Kit and Cable

Replacing the Resistor Only

Replacing Parts and Cleaning the Gun

Assembling the Gun

External Parts

Final Assembly and Adjustments

Gun Assembly

Recommended Spare Parts

Air Valve Service Kit

Handle Replacement Kit

Extension Service Kit

Optional Isocoils

High-Conductivity Isocoil

specifications

Air Quality

Nordson AN-8 Plus Customer Product Manual

AN-8 Plus