Safety 1-7 1999 Nordson CorporationAll rights reserved 107 962HIssued 11/99Manual 21-19Table 1-1 contains the text of the safety label on this equipment. Thesafety label is provided to help you operate and maintain your equipmentsafely. See Figure 1-1 for the location of the safety label.Table 1-1 Safety LabelsItem Part Description1. 241 162 WARNING: High voltage. Read manual before using. All conductive objects in area must begrounded.— 600 001 WARNING: The following procedures MUST be followed when working with this electrostaticspray equipment. Failure to follow these instructions may result in a fire and/orserious personal injury. Display this warning on the spray booth.1. NO SMOKING. Keep open flames, hot surfaces, and sparksfrom torches or grinding away from booth.2. Turn the electrostatic power unit OFF when the spray gun isnot in use.3. Appropriate control interlocks and fire suppression apparatusmust be installed and operative.4. Ground the power unit, the spray booth, work hangers,conveyor rollers, channels, and all other conductive objectswithin approximately 3 m (10 ft) of the electrostatic spay gun.THE FLOOR MUST BE CONDUCTIVE AND GROUNDED.5. Examine all equipment at the beginning of each work periodand repair or replace any damaged, loose, or missing parts.6. Maintain grounding of all work pieces. Work hangers,conveyor rollers, channels, etc. MUST BE CLEAN. Electricalsparks from discharge of static accumulation are capable ofigniting fires. If any sparking is seen around the workpiece,conveyors, or other metal objects in the area, immediatelyshut down the process and correct grounding beforecontinuing process.7. Operator must be grounded to prevent shocks from staticelectricity. Floor surface must be conductive. Footwear andgloves must be static dissipative in accordance with ANSIZ41-1991.8. Before cleaning the nozzle or performing any work on theelectrostatic spray gun, turn off the power unit and ground thenozzle. The nozzle MUST BE REMOVED for cleaning. Usea non-flammable solvent in a non-conductive container, i.e.glass container.Continued on next page9. Safety Labels

Issued

Manual

Introduction

Personal Safety

High-Pressure Fluids

Fire Safety

Halogenated Hydrocarbon Solvent Hazards

Safety Labels

H Manual

Options

Typical Heated Circulating System

Theory of Operation

Installing the Cable to the AN-8 Plus Gun

Installing the Gun

Installing the Air Flow Switch, Hoses, and Fittings

Securing the Hoses and Gun

Checking the Gun After Installation

Installing a New Extension Resistor Kit and Cable

Daily

Gun Maintenance

Mechanical Problems

Electrostatic Problems

Disassembling the Gun

Internal Parts

Replacing the Extension Resistor Service Kit and Cable

Replacing the Resistor Only

Replacing Parts and Cleaning the Gun

Assembling the Gun

External Parts

Final Assembly and Adjustments

Gun Assembly

Recommended Spare Parts

Air Valve Service Kit

Handle Replacement Kit

Extension Service Kit

Optional Isocoils

High-Conductivity Isocoil

specifications

Air Quality

Nordson AN-8 Plus Customer Product Manual

AN-8 Plus