Operation4-4Part 1604870-05 2018 Nordson CorporationFactory Set PresetsPresets are programmed electrostatic and powder flow setpoints for aparticular part or application. Up to 20 presets can be programmed.The system is shipped with presets 1−3 already programmed. See Table4-3 and 4-4 for default preset values for the both the HD and XT systems.Refer to Presets on page 4-5 for programming instructions.Table 4-3 HD System Factory Set PresetsPreset Electrostatics, Powder Flow kV A %1 Max kV, 150 g/min (20 lb/hr) 100 30 35 0.72 Max kV, 300 g/min (40 lb/hr) 100 30 80 1.03 Select Charge 3 (deep recess), 150 g/min (20 lb/hr) 100* 60* 35 0.7* Select Charge Mode settings are factory set and cannot be changed.Table 4-4 XT System Factory Set PresetsPreset Electrostatics, Powder Flow kV A % 1 Max kV, 150 g/min (20 lb/hr) 100 30 45 3.02 Max kV, 300 g/min (40 lb/hr) 100 30 75 3.03 Select Charge 3 (deep recess), 150 g/min (20 lb/hr) 100* 60* 45 3.0* Select Charge Mode settings are factory set and cannot be changed.Using the Controller InterfaceInterface ComponentsUse the controller interface to make preset settings, view help codes,monitor system operation, and configure the controller. See Figure 4-2.Gun Triggered On IndicatorSelect ChargeModeskV SettingFunction/Help DisplayCurrent Preset NumberPowder Flow %Rotary KnobStandby ButtonNordson Button(Configuration)Setting Button LEDsPreset SelectSetting IconsPattern Air Flow SettingμA SettingHelp ButtonView Button Enter ButtonColor Change ButtonFigure 4-2 Controller Interface