System Setup3-16Part 1604857-04 2014 Nordson CorporationController ConfigurationPower Up SequenceWhen power is applied to the system, the controller goes through thefollowing sequence:1. All displays and LEDs light for 3 seconds.2. The main control board configuration is displayed on the KV/A panel:A: Auto (refer to troubleshooting to change the jumper if A is displayed)H: Manual3. The controller software and hardware version are displayed on theKV/A panel in the form N.NN for 1 second.NOTE: If the spray gun is triggered on during power-up or wake up fromdisable, the trigger LED blinks at a fast rate. Release the trigger and repeatthe sleep/wake up cycle.Entering Configuration ModeTo enter configuration mode, press and hold the Plus and Minus buttons onthe kV/uA panel while either turning on power or pressing theEnable/Disable button (if the controller is already powered up). After 1second all panels flash CF for 3 seconds. After 3 seconds the kV/A paneldisplays F − 1 for function 1. The controller is now in configuration mode.To save your settings and exit Configuration Mode, press theEnable/Disable button.Atomizing Air(Classic)Total Flow(Smart Flow)Setting/DisplaySelect ChargeMode SettingsKV/A Setting/DisplayKV/uA SelectionControlSmart Flow ModeIndicatorFlow-Rate Air(Classic)Powder Flow Rate(Smart Flow)Setting/DisplayEnable/Disable Trigger LEDFigure 3-16 Controller Interface
