Operation 4-9Part 1604857-04 2014 Nordson CorporationTube BracketPickup TubePickup Tube ArmFigure 4-6 Pickup Tube Bracket Use2. Place a box of powder on the vibrator table.3. Fold back the box flaps and open the plastic bag containing the powdercoating. Fold the bag over the box flaps to keep the flaps out of the way.NOTE: Do not force the end of the pickup tube into the powder. Vibrationand gravity will cause the pickup tube to sink into the powder.4. Swing the tube bracket out from under the pickup tube and slide thetube down into the powder.5. To prevent accidental powder spills, wrap the plastic bag around thepickup tube and loosely secure the bag with a tie wrap.Vibratory Box Feeder OperationWhen the controller is configured for a vibratory feed system, the vibratorybox feeder relay control is enabled. The relay turns on the vibrator motorwhen the spray gun is triggered.When the spray gun is triggered off, the vibrator motor remains on for aconfigurable delay. This delay prevents rapid on/off motor cycling every timeyou trigger the gun off and on and prolongs the life of the motor. The defaultdelay time is 30 seconds.The vibrator motor can also be set to continuous operation. If set this way,press and release the spray gun trigger to start the motor. To turn off themotor, press the Enable/Disable button or turn off controller power.To configure the system for a vibratory box feeder, change the VBF delaytime, or set the vibrator motor to continuous operation, refer to page 3-16.
