70 Configure the Media Gateway Controller and DSP daughterboards in a PRI GatewayFor more information about configuring DTMF tone detection (DTR),see Communication Server 1000E Installation and Commissioning(NN43041-310).Procedure 12Configuring the Media Gateway Controller on a Call Server using LD 97Step Action1 Log on to the CS 1000E Call Server.2 To access LD 97, enter:LD 973 Enter the responses shown in Table 13 "Media GatewayController configuration (LD 97)" (page 70).Table 13Media Gateway Controller configuration (LD 97)Prompt Response DescriptionREQ aaa Request (aaa = CHG, NEW)TYPE Supl SuperloopSUPL 0–252 Superloop number. Add prefix X to delete.SLOT Select default.SUPT IPMG IP Media GatewayThe following prompts are for IPMG superloops only.IPR0 nn.nn.nn.nn Shelf 0 IPMG Uplink IP address. to skip to IPR1when configuring new superloop; X to remove IPR0, DES0,and ZONE0 data.IPMG_TYPE MGC IPMG is controlled by MGC card.ZONE0 0-8000 Shelf 0 IPMG zone number. Zones used for IPMGpurposes must be configured as shared so that other IPdevices that are not in the same zone can gain access tothe IPMG devices.DES0 No input, simply a header for the ELAN/TLAN designators.This header and the ELAN/TLAN prompts only apply toMGC-based IPMGs.... ...DES1 No input, simply a header for the ELAN/TLAN designators.This header and the ELAN/TLAN prompts only apply toMGC-based IPMGs.... ...--End--Nortel Communication Server 1000Media Gateway 1000E PRI Gateway Installation and CommissioningNN43041-311 04.01 4 June 2010Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
