Configure the Media Gateway Controller 71Procedure 13Configuring Media Gateway Controller Tone and Conference using LD 17Step Action1 Log on to the CS 1000E Call Server.2 To access LD 17, enter:LD 173 Enter the responses shown in Table 14 "Media Gateway toneand Conference configuration (LD 17)" (page 71).Table 14Media Gateway tone and Conference configuration (LD 17)Prompt Response DescriptionREQ CHGTYPE CFN Configuration record.CEQU YES Common equipment....MGTDS aaa bbb Allows the configuration of two Media Gateway TDSloops simultaneously.aaa = loop, bbb = 0–255, X to delete the loopIPMG supl sh Superloop and shelf of IPMG on which this MGTDS areassociated. No default value is assigned if the IPMG isnot associated. This prompt allows for the associationof the MGTDS with a particular IPMG.supl = IPMG superloop, sh = IPMG shelfMGCONF aaa bbb ccc ddd Allow the configuration of up to four Media Gatewayconference loops simultaneously.aaa = loop, bbb = 0–255, X to delete the loopIPMG supl sh Superloop and shelf of IPMG on which this MGTDS areassociated. No default value is assigned if IPMG is notassociated. This prompt allows for the association ofthe MGTDS with a particular IPMG.supl = IPMG superloop, sh = IPMG shelf--End--Configure the Media Gateway ControllerThe MGC command line can be accessed using the NTBK48AA three-portSDI cable. A null modem adapter is used to connect to the MGC serialport.Nortel Communication Server 1000Media Gateway 1000E PRI Gateway Installation and CommissioningNN43041-311 04.01 4 June 2010Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
