Using the Console Interface309985-C Rev 00 3-45Predefined Protocol Identifier (PID) DescriptionTable 3-14 defines the standard protocol-based VLANS and PID types that aresupported by the BayStack 410-24T switch:Table 3-14. Predefined Protocol Identifier (PID)PID Name Encapsulation PID Value (hex) VLAN TypeIp Ether2 Ethernet Type 2 0800, 0806 Standard IP on Ethernet Type 2 framesIpx 802.3 Ethernet 802.2 FF FF Novell IPX on Ethernet 802.3 framesIpx 802.2 Ethernet 802.2 E0 E0 Novell IPX on Ethernet 802.2 framesIpx Snap Ethernet Snap 8137, 8138 Novell IPX on Ethernet SNAP framesIpx Ether2 Ethernet Type 2 8137, 8138 Novell IPX on Ethernet Type 2 framesAplTk Ether2Snap Ethernet Type 2 orEthernet Snap809B, 80F3 AppleTalk on Ethernet Type 2 and EthernetSnap framesDeclat Ether2 Ethernet Type 2 6004 DEC LAT protocolDecOther Ether2 Ethernet Type 2 6000 - 6003,6005 - 6009,8038Other DEC protocolsSna 802.2 Ethernet 802.2 04 **, ** 04 IBM SNA on IEEE 802.2 framesSna Ether2 Ethernet Type 2 80D5 IBM SNA on Ethernet Type 2 framesNetBios 802.2 Ethernet Type 2 F0 **, ** F0 NetBIOS ProtocolXns Ether2 Ethernet Type 2 0600, 0807 Xerox XNSVines Ether2 Ethernet Type 2 0BAD Banyan VINESIpv6 Ether2 Ethernet Type 2 86DD IP version 6User-Defined Ethernet Type 2,Ethernet 802.2, orEthernet SnapUser-defined16-bit valueUser-defined protocol-based VLAN (see“User-Defined Protocol Identifier (PID)Description” on page 3-46).Rarp Ether2 Ethernet Type 2 8035 Reverse Address Resolution Protocol(RARP):RARP is a protocol used by some olddiskless devices to obtain IP addresses byproviding the MAC layer address. When youcreate a VLAN based on RARP, you canlimit the RARP broadcasts to the ports thatlead to the RARP server.
