Using the BayStack 410-24T 10BASE-T Switch3-114 309985-C Rev 00Software DownloadThe Software Download screen (Figure 3-47) allows you to revise the BayStack410-24T switch software image that is located in nonvolatile flash memory.To download the BayStack 410-24T switch software image, you need a properlyconfigured Trivial File Transfer Protocol (TFTP) server in your network, and anIP address for the switch (or stack, if configured). To learn how to configure theswitch or stack IP address, see “IP Configuration” on page 3-8.You can monitor the software download process by observing the BayStack410-24T switch LEDs (see “LED Indications During the Download Process” onpage 3-116.Caution: Do not interrupt power to the device during the software downloadprocess. If the power is interrupted, the firmware image can become corrupted.Achtung: Unterbrechen Sie die Stromzufuhr zum Gerät nicht, während dieSoftware heruntergeladen wird. Bei Unterbrechung der Stromzufuhr kann dasFirmware-Image beschädigt werden.Attention: Ne pas couper l'alimentation de l'appareil pendant le chargementdu logiciel. En cas d'interruption, le programme résident peut être endommagé.Precaución: No interrumpa la alimentación del dispositivo durante elproceso de descarga del software. Si lo hace, puede alterar la imagen de laprogramación (firmware).Attenzione: Non interrompere l'alimentazione elettrica al dispositivo duranteil processo di scaricamento del software. In caso di interruzione, l'immaginefirmware potrebbe danneggiarsi.
