106 Nortel IP Phone 2004Installation and configurationThe following sections provide a step-by-step guide to install and configurethe IP Phone 2004:• "Before you begin" (page 106)• "First-time installation" (page 106)• "Configuring the IP Phone 2004" (page 107)• "Startup sequence" (page 109)• "Installing the IP Phone 2004" (page 110)Before you beginBefore installing the IP Phone 2004, complete the following pre-installationchecklist:• Ensure one IP Phone 2004 boxed package exists for each IP Phone2004 you install. The package contains:— IP Phone 2004— handset— handset cord— 2.1 m (7-ft) CAT5 Ethernet cable— Getting Started Card• Ensure one Software License exists for each IP Phone 2004 you install.• Ensure the host Call Server is equipped with a Signaling Server thatruns the Line TPS application.• If an AC power adapter is required, ensure you use the correct AC powertransformer. The voltage rating of the transformer must match the walloutlet voltage. See Table 11 "IP Phone 2004 component list" (page 104).First-time installationYou must first install an IP telephony node with the Communication Server.For information about installing an IP telephony node, see Signaling ServerInstallation and Commissioning (NN43001-312) or IP Line Fundamentals(NN43100-500).CAUTIONDo not plug your IP Phone 2004 into an ISDN connection. Severedamage can result.Nortel Communication Server 1000IP Phones FundamentalsNN43001-368 02.01 StandardRelease 5.0 7 December 2007Copyright © 2003–2007, Nortel Networks.
