532 Appendix G Bluetooth wireless technologyEnabling Bluetooth wireless technologyThe following methods are available to enable Bluetooth wireless technologyon the IP Phone• Manual configuration— is used to set the Bluetooth wireless technologymode on the IP Phone on a phone-by-phone basis. If manualconfiguration is used exclusively, a TFTP server is not required toconfigure Bluetooth wireless technology. For further information aboutmanual configuration, see "Manual configuration" (page 532).Use Procedure 128 "Configure the Bluetooth wireless technologyadministration setting" (page 533) to configure the Bluetooth wirelesstechnology through the Local Tools > Network Configurationsubmenu.• TFTP configuration—is used to initially set the Bluetooth wirelesstechnology mode then the TFTP Server can be removed. The IP Phonenow retains the value and uses the last value received if no new valueis received.Use Procedure 129 "Enabling Bluetooth wireless technology on theIP Phone 1140E" (page 534)to enable Bluetooth wireless technologyon the IP Phone 1140E using the TFTP configuration file (1140e.cfg)retrieved during bootup.If Bluetooth wireless technology is enabled on your phone, andpassword-protection for the Local Tools menu has been enabled, youcan still double-press the Headset key to access the menu.Manual configurationYou can enable or disable Bluetooth wireless technology through theNetwork Configuration menu. The Enable Bluetooth option providesadministration control over Bluetooth wireless technology. The followingvalues are available• Auto—(default) Bluetooth wireless technology setting received throughTFTP configuration• Yes—Bluetooth wireless technology is enabled on the IP Phone• No—Bluetooth wireless technology is disabled on the IP PhoneWhen the IP Phone 1140E firmware is upgraded, or when the IP Phone isreceived from the manufacturer with the latest firmware, the default powerup setting is Auto. When the setting is Auto, the setting received from theTFTP Device Config file controls whether Bluetooth wireless technologyis enabled.When the Bluetooth wireless technology setting is Yes or No, the valuereceived from the TFTP Device Config file is saved but is not used. TheBluetooth wireless technology administration setting is forced enabled, orNortel Communication Server 1000IP Phones FundamentalsNN43001-368 02.01 StandardRelease 5.0 7 December 2007Copyright © 2003–2007, Nortel Networks.
