Chapter 15 Firmware and configuration file maintenance 187Nortel Business Secure Router 222 Configuration — AdvancedRestore Using FTPFor details about back up using FTP and TFTP, refer to “Backup configuration”on page 180.Figure 97 Telnet into Menu 24.61 Launch the FTP client on your computer.2 Enter open, followed by a space and the IP address of your Business SecureRouter.3 Press [ENTER] when prompted for a username.4 Enter your password as requested (the default is “PlsChgMe!”).5 Enter bin to set transfer mode to binary.6 Find the rom file (on your computer) that you want to restore to your BusinessSecure Router.7 Use put to transfer files from the Business Secure Router to the computer, forexample, “put config.rom rom-0” transfers the configuration file config.romon your computer to the Business Secure Router. See “Filename conventions”on page 179 for more information about filename conventions.Menu 24.6 -- System Maintenance - Restore ConfigurationTo transfer the firmware and configuration file to your workstation,follow the procedure below:1. Launch the FTP client on your workstation.2. Type "open" and the IP address of your Business Secure Router. Then type"nnadmin" and SMT password as requested.3. Type "put backupfilename rom-0" where backupfilename is the name ofyour backup configuration file on your workstation and rom-0 is theremote file name on the Business Secure Router. This restores theconfiguration to your Business Secure Router.4. The system reboots automatically after a successful file transferFor details on FTP commands, please consult the documentation of your FTPclient program. For details on backup using TFTP (note that you must remainin this menu to back up using TFTP), please see your Business Secure Routermanual.Press ENTER to Exit:
