192 Chapter 15 Firmware and configuration file maintenanceNN47922-501(config.rom) to the Business Secure Router and renames it rom-0. Likewiseget rom-0 config.rom transfers the configuration file on the Business SecureRouter to your computer and renames it “config.rom.” See “Filenameconventions” on page 179 for more information about filename conventions.7 Enter “quit” to exit the ftp prompt.FTP Session Example of Firmware File UploadFigure 104 FTP Session Example of Firmware File UploadMore commands (found in GUI-based FTP clients) are listed earlier in thischapter.Refer to the “Remote Management” on page 209 section to read aboutconfigurations that disallow TFTP and FTP over WAN.TFTP file uploadThe Business Secure Router also supports the uploading of firmware files usingTFTP (Trivial File Transfer Protocol) over LAN. Although TFTP also works overWAN, Nortel does not recommend doing this.1 To use TFTP, your computer must have both Telnet and TFTP clients. Totransfer the firmware and the configuration file, follow the procedure shownnext.Note: The Business Secure Router automatically restarts after asuccessful file upload.331 Enter PASS commandPassword:230 Logged inftp> bin200 Type I OKftp> put firmware.bin ras200 Port command okay150 Opening data connection for STOR ras226 File received OKftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.ftp> quit
