Chapter 6 Remote Node setup 95Nortel Business Secure Router 222 Configuration — AdvancedRemote Node filterMove the cursor to the field Edit Filter Sets in menu 11.1, and then press[SPACE BAR] to set the value to Yes. Press [ENTER] to open Menu 11.1.4-Remote Node Filter.Use menu 11.1.4 to specify the filter sets to apply to the incoming and outgoingtraffic between this remote node and the Business Secure Router to preventcertain packets from triggering calls. You can specify up to 4 filter sets separatedby commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces areaccepted in this field. For more information about defining the filters, refer toChapter 11, “Filter configuration,” on page 135. For PPPoE or PPTPencapsulation, you have the additional option of specifying remote node call filtersets.Version Press [SPACE BAR] and then [ENTER] to select the RIPversion from RIP-1/RIP-2B/RIP-2M or None.N/AMulticast IGMP (Internet Group Multicast Protocol) is anetwork-layer protocol used to establish membership in aMulticast group. The Business Secure Router supportsboth IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).Press [SPACE BAR] to enable IP Multicasting or selectNone to disable it.None(default)After you complete filling in Menu 11.1.2 Remote NodeNetwork Layer Options, press [ENTER] at the message“Press ENTER to Confirm...” to save your configurationand return to menu 11.1, or press [ESC] at any time tocancel.Table 22 Remote Node Network Layer Options Menu FieldsField Description Example
