34 Chapter 4 DN records parametersN0027269 01N0027269 01Line Access - Answer DNs tabProgram a telephone to provide automatic call alerting and call answering for other telephones inthe system. The DNs of the other telephones are referred to as Answer DNs (see Figure 5).Figure 5 Line Access - Answer DNs tabVmsg Set Select whether an indicator shows on the telephone for a voicemessage waiting on an external voice message system.The line must appear on the receiving telephone.Note: The Message Waiting Indicator (MWI) is currently supportedexclusively by Meridian Mail and CallPilot.MCDN note: If your system is part of an MCDN network connectedto a Meridian 1 system, and you are using the voicemail system offthe Meridian 1, you must enable this field.Analog lines connected to legacy analog ASM station modules, andanalog telephones attached to an ATA device, do not provide visiblemessage waiting indication. Analog telephones connected to aGASM8 support message indicators, if the telephone is set up toreceive them.Note: Contact your voice message service provider to find out if your voice message serviceworks with BCM50, or if you have any problems with your service.Priv. Received #(Target lines only)These fields reflect the settings defined under target lines.These are the digit strings that the system uses to identify a call for this telephone.Refer to BCM50 Networking Configuration Guide (N0027156) for more information aboutTrunk/Line Data in the main panel.Pub. Received #(Target lines only)ActionsAdd To add a line to a telephone:1. On the System DNs table (Line Access tab), choose the DN record where you want toadd lines.2. Under the Assigned Lines table in the bottom panel, click Add.3. Enter a line number in the dialog box.4. Click OK to save the line to the list.Delete 1. On the System DNs table (Line access tab), choose the DN record where you want todelete lines.2. On the Assigned Lines table in the bottom panel, select a line you want to delete.3. Click Delete.4. Click OK to confirm the selection.Table 4 Telephone line assignment fields (Sheet 2 of 2)Attribute Values Description