Chapter 4 DN records parameters 39BCM50 IP Telephone Installation and Configuration GuideCapabilities and Preferences - Preferences tabThe Preferences headings allow you to program the same settings that users can perform at theirtelephones and the settings for configuring a telephone as a hotline. The telset admin options areonly available to digital phones and IP telephones (see Figure 8).Figure 8 Capabilities and Preferences - Preferences tab panelAllow redirect Define whether this telephone allows assigned lines to be redirected.This must be selected to allow call forwarding outside the network (externalcall forward), including calls to a centralized voicemail system over a privatenetwork.Redirect ring Define whether the telephone rings briefly when a call on one of its lines isredirected by the Line Redirection feature (FEATURE 84).Refer to BCM50 Networking Configuration Guide (N0027156) for moreinformation about Trunk/Line Data in the main panel.Receive short tones Analog equipment that is connected to the system with an internal or externalanalog terminal adapter (ATA2), responds only to tone dialing signals.Select this setting only if you have analog equipment connected to a stationport. Otherwise, do not select Receive short tones.Silent monitorsupervisor On two-line display telephones only, you can choose whether the telephonecan be used to allow the Silent Monitor feature. Select the checkbox to allowthis feature on this telephone.Table 7 Capabilities and Preferences - Capabilities panel fields (Sheet 3 of 3)Attribute Values Description