230 System maintenanceDAP Controller deactivationYou can use the DAP Controller to configure the SIP DECT system. Inaddition, as long as the DAP Controller is connected and active, it canperform the following functions:• Process messaging (Low Rate Messaging and interaction with DECTMessenger).• Move subscriptions from a DAP that is not working to working DAPs.After a DAP is unavailable for 15 minutes, the system considers it tobe not working.• Monitor the SIP DECT system and send archives and alarms by email.After you have configured the SIP DECT system using the DAP Controller,you can perform either of the following:• Leave the DAP Controller PC connected and active, so that it performsall the functions listed above, and you can use it at any time toconfigure the SIP DECT system.• Deactivate the DAP Controller software. You can then use the DAPController PC for other purposes, and if necessary you can disconnectit from the network completely. You can reactivate the DAP Controllersoftware at any time to configure the SIP DECT system.If you choose to disconnect your DAP controller PC from the network,you must first complete the following procedure to deactivate SIP DECTservices.Procedure 116Deactivating SIP DECT servicesStep Action1 Launch DAP Configurator2 In the IP DECT Configurator main window, click Activate/Deactivate/System Status.3 Click Deactivate All to stop all enabled services and programs.4 Once the system is deactivated, click Exit.--End--DAP Controller software deinstallationIf you need to remove the DAP Controller software, use the steps in thefollowing procedure.Nortel Communication Server 1000SIP DECT FundamentalsNN43120-123 01.076 January 2009Copyright © 2008-2009 Nortel Networks.
