98 Chapter 9 RAID operations5 Enter 4 to run the LSI320-1 RAID card firmware update from theNortel CallPilot Image Menu.Result: The system prompts you to confirm the RAID firmwareupdate.6 Enter Y to confirm.Result: The system displays the valid image for the RAID cardfirmware update and asks the following:Do you wish to continue (y/n)?7 Type Y and press Enter.Result: The system states that you are flashing the Firmware (itdisplays the version), and asks the following:Do you wish to continue (y/n)?8 Type Y and press Enter.Result: The Flash programming is performed. Once complete, thesystem prompts for you to reboot the system.9 Manually reboot the CallPilot 1005r.Result: The system reboots and the Startup Menu appears.10 Remove the DVD from the DVD combo Drive.11 Restart the server.—End—Configuring RAID using LSI320-1 controller and Ctrl+MThe configuration of the RAID card is stored on both the card and the harddrive. Typically you are not required to reconfigure RAID unless you aremaking a change to the RAID system (for example, if you replace the harddrives with higher capacity hard drives).CAUTIONRisk of data lossThis procedure requires that the logical drive be initialized. Whenyou initialize the logical drive, all data on the hard drives is erased.Do not perform this procedure unless you are replacing thehard drives or you are rebuilding the CallPilot system (that is,reinstalling the Windows operating system and CallPilot software).Nortel CallPilot1005r Server Maintenance and DiagnosticsNN44200-704 01.06 Standard5.0 19 July 2007Copyright © 2007, Nortel Networks.
