Configuring Remote Access for AN and Passport ARN RoutersC-4 308614-14.20 Rev 00Global Information WorksheetThis section contains the prompts and options for all AN/ANH or ARN routersynchronous configurations.Global Information WorksheetPrompt Options Your ResponseEnter the module number[1]:AN/ANH only: Because the AN/ANH is not alink module, the router bypasses this stepand automatically accepts a default slot of 1.ARN only: The script lists the modules thatyou can use to connect the router’s IPnetwork interface to Site Manager.For example, the script might offer thefollowing options:1. Ethernet on Base Module2. Serial on Adapter Module 13. Ethernet Tri-Serial on Expansion ModuleEnter the number thatcorresponds to themodule you want to use.Driver Type: If there is only one interface on the moduleyou chose, the script automatically selectsthe driver type for that interface andbypasses this prompt. Otherwise, the scriptdisplays a menu of driver types. The actualmenu depends on the modules you haveinstalled.Enter the number thatcorresponds to the driverfor the module youselected.For serial interfaces andall WAN adapter modules,choose the synchronousdriver.Enter connector number[1]:If there is only one connector on the moduleyou chose, the script automatically assigns aconnector number and bypasses this prompt.Otherwise, the script lists the availableconnectors. For example, for an ARN withfive serial connectors, the options are asfollows:1. COM12. COM23. COM34. COM45. COM5For information about themodule locations andconnector names, seeTables 3-1 to 3-4 inChapter 3.(continued)