Using the Quick-Start Local Boot Procedure308614-14.20 Rev 00 C-13Running the Quick-Start ScriptTo quick-start an AN/ANH or ARN router, you run the install.bat (AN/ANH) orinst_arn.bat (ARN) Technician Interface script, and respond to the prompts. Therouter automatically selects options for some prompts, and you can accept defaultvalues for many of the other prompts. You run the script as part of the Local Bootprocess.To perform the Quick-Start procedure:1. Make sure that you have the completed worksheets with you.2. Start the router.3. At the Technician Interface prompt, enter Manager to log in.The Technician Interface mounts the local file system and displays thecommand-line prompt.4. To ensure that the router is using the configuration file (config) on thelocal flash memory card, issue the getcfg command.Look for the following line in the getcfg command display:boot config = localSMDS WorksheetRequested Information Options Your ResponseEnter 10-digit individualaddress:Enter the individual addressassigned by your SMDS serviceprovider.Enter 10-digit group address: Enter the group address assignedby your SMDS service provider.Enter 10-digit arp address: Enter the Address ResolutionProtocol (ARP) address assignedby your SMDS service provider.Note: Manager is case-sensitive; use an uppercase M.