Understanding Tools and Options308614-14.20 Rev 00 1-19You can use Netboot for some procedures and Local Boot for others, provided youhave set up the network to support Netboot.EZ-InstallComplete the following steps for the EZ-Install option:1. Use the Configuration Manager in local mode to create a completeconfiguration file for the router. (See Chapter 3 and Configuring andManaging Routers with Site Manager.)2. Set up a UNIX workstation on the network to support BootP. (See Chapter 2.)3. Create a BootP client on the upstream router to support automated addressing,and configure all routers between the BootP server and the AN/ANH or ARNrouter as BootP relay agents. (See Chapter 3.)4. Ensure that there is a network connection from a synchronous interface on theAN/ANH or ARN router to the upstream router.5. A person at the AN/ANH or ARN router site installs and turns on the router.(See the model-specific hardware installation guide.)The AN/ANH or ARN router obtains a software image from its local filesystem, an IP address from the upstream router, and the customizedconfiguration file from the BootP server. (“The Boot Process” on page 1-5describes this process; no action is required.)If the configuration file meets your network requirements, the AN/ANH orARN router starts bridging and routing traffic.6. Use the Site Manager Statistics Manager and Events Manager tools to verifythat the AN/ANH or ARN router is routing traffic as specified in theconfiguration file. (See Configuring and Managing Routers with SiteManager.)Note: To boot an AN/ANH or ARN router over the network, all routers in thepath to the BootP server must be running BayRS Version 7.60 or later.Note: If the AN/ANH or ARN router will connect to the upstream router overa frame relay circuit, ensure that the upstream router is running BayRS Version7.80 or later.
