Configuring Remote Access for AN and Passport ARN RoutersA-2 308614-14.20 Rev 00Netboot and Directed Netboot ParametersParameter: Boot Image From NetworkPath: Configuration Manager > Protocols > Global Protocols > Net Boot > GlobalDefault: DisableOptions: Enable | DisableFunction: Enables or disables retrieval of the boot image from the BootP server the nexttime the router starts up.Instructions: Set to Disable if you want to boot using the image in the router’s local filesystem. This setting reduces the time it takes to boot the router and eliminatesusing network resources to obtain the image.Set to Enable if:• You want the router to obtain the image from a BootP server and you havealready set up the network to support BootP.• You are upgrading the image on several routers. The routers can then bootusing a single image on the BootP server. Make sure that the directory namein the bootptab file matches the location of the upgraded image before youboot the routers.MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.1.1Parameter: Boot Config From NetworkPath: Configuration Manager > Protocols > Global Protocols > Net Boot > GlobalDefault: EnableOptions: Enable | DisableFunction: Enables or disables retrieval of the configuration file from the BootP server thenext time the router starts up.Instructions: Set to Disable if you have already saved the configuration file to the router’sflash memory file system, and you want to boot using this configuration file.This setting reduces the time it takes to boot the router and eliminates usingnetwork resources to obtain the configuration file.Set to Enable if you want the router to obtain the configuration file from a BootPserver and you have already set up the network to support BootP.MIB Object ID: 1.3.6.1.4.1.18.3.3.2.10.1.2