Setting up the System Standard 3.066 Nortel TDM RecorderSetting up overviewThis chapter describes licensing and initial configuration tasks you performafter the installation to set up and verify the installation. After you havesuccessfully placed and viewed a test call, the installation is complete.You do not have to assign ports for Recorder components, as this is doneautomatically by the installation program. Detailed configurationprocedures appear in the Nortel TDM Recorder System AdministrationGuide.Note: You must be a user with Administrator rights to carry out anyconfigurations with the Recorder Manager.After installation, you should carry out the steps below, in the order listed.1 Set up your License for the first timeIn this step, you either set up a temporary license that will last for 10days, until you obtain the full licence, or activate your full license.2 Configure Adapter Cards for first time useIn this step, you configure each voice card installed so that it will work inthe telephony environment and record calls.3 Verify the installationIn this step, you make a call and check the results using a viewerapplication. Once you have done this, installation is complete.Setting up the System is described in the following topics: Setting up your license for the first time Configuring adapter cards Verifying the installation
