Nortel TDM Recorder Installation Manual

Also see for TDM Recorder: User guide

Contents

September 2007 Configuring Non-Facility Associated SignalingInstallation Guide 81DefinitionsThe following definitions are used in this appendix. The following termsmay not be universally applicable, but they are used in this appendix todistinguish similar items from one another:1 Ai Logix Card ID: An ID number assigned to each Ai Logix card by the AiLogix driver. This ID is visible in the Smart Control program.2 Ai Logix NFAS Trunk Group: This appears as “NFAS Group” on theRecorder Manager Voice Card page and “NFAS Index” in the Ai LogixSmart Control program. This value must correlate with the Switch TrunkGroup, but must start at 0 and increment by 1. You might have TrunkGroups 1 and 6, but the Ai Logix NFAS Trunk Groups would be 0 and 1.3 Ai Logix NFAS Trunk Index: This appears as “NFAS Index” on theRecorder Manager Voice Card page and “Trunk Index” on the Ai LogixSmart Control program. This value must correlate with the Switch TrunkSpan Index, but will start at 0 for Ai Logix NFAS Trunk Group 0 andincrement by 1. This value does not start over at 0 for Ai Logix NFASTrunk Group 1.4 Ai Logix NFAS Trunk Type: This appears as “NFAS Type” on theRecorder Manager Voice Card page and “Trunk Type” in the SmartControl program. This identifies the Trunk Span as either “D” for D-channel, “Backup” for the backup D-channel, or “None” for Trunk Spansthat do not contain D-channels.5 Ai Logix Port: The RJ-45 connector on the Ai Logix DP6409 card. Thereare two, called “Trunk1” and “Trunk2”, in Recorder Manager. Trunk1 willbe the top connector in a vertical PCI card configuration or the left-handconnector in a horizontal configuration. Trunk2 will be the bottom or left-hand connector.6 Ai Logix Serial #. The last 4 digits of the Ai Logix serial #. This willtypically appear on the external side of the card so it can be seen on theback of the racked server.7 Cable Identifier: A label on the wires running from the trunk-tap point tothe TDM Recorder. This could also refer to a patch panel port, or acombination of the patch panel port and wire number. For example,