Appendix B: Dialing Translation 63P0886629 Issue 1.0 FAX Set Up and Operation GuideReviewing the entries in the Dialing Translation TableYou can review or check the entries in your Dialing Translation Table at anytime.To review your Dialing Translation Table entries:1. Press ƒ · ° ‹.2. Enter the System Coordinator Mailbox number andpassword and press OK.3. Press ° °.4. Press TABLE. If Centrex is installed on your Norstarsystem, QUIT is replaced by NEXT.5. Press CHNG.6. Press NEXT to view the next entry in the DialingTranslation Table.Note: The display shows 16 characters. If the totalnumber of Input and Output values equalsmore than 16 digits a VIEW> softkey willappear on the left side of the display. Afteryou have pressed VIEW> to view the digitsfurthest to the right, the softkey changes to. Press the softkey to view thedigits on the left again. The inval*outval* is an example of a Table entry.The * character shown after a valuesignifies any digits in the telephone numberremaining to be dialed. Norstar Voice Mailautomatically adds the * character afterevery Input and Output value.7. Continue pressing NEXT to view all the entries inthe Dialing Translation Table.8. Press ® to end this programming session.Log:QUIT RETRYAdminMBOX AA OTHRDialingPARM QUITDial tableADD QUITinval* outval*OTHRinval* outval*OTHR