Figure 6-20 Parent Directory Child directory: It is a sub-folder which can be created in the parent directory. The fileswill be saved in a sub-folder in FTP server. The name of folder can be defined as shownin following Figure 6-21.Figure 6-21 Child Directory Upload type: To enable uploading the captured picture to the FTP server.3. Click to save the settings.4. You can click Test to confirm the configuration.If you want to upload the captured pictures to FTP server, you also have to enable thecontinuous snapshot or event-triggered snapshot in Snapshot interface. For detailedinformation, please refer to the Section 7.3 Configuring Snapshot Settings.6.3.9 Configuring UPnP™ SettingsUniversal Plug and Play (UPnP™) is a networking architecture that provides compatibility amongnetworking equipment, software and other hardware devices. The UPnP protocol allows devicesto connect seamlessly and to simplify the implementation of networks in the house andcorporate environments.With the function enabled, you don’t need to configure the port mapping for each port, and thecamera is connected to the Wide Area Network via the router.Steps:1. Enter the UPnP™ settings interface.Configuration >Advanced Configuration > Network > UPnP2. Check the checkbox to enable the UPnP™ function.You can edit the Friendly Name of the speed dome. This name can be detected bycorresponding device, such as a router.Figure 6-22 Configure UPnP Settings
