47 AFP-3030 Operations Manual — P/N DOC-01-039:A 26/11/2015Read Status General ZoneMANUAL ON <Fault Status>*MANUAL OFF-HOOK <Fault Status>*If the point is disabled, the display will read as follows. will appear when there is apoint fault.DISABLED OFF <Fault Status>*DISABLED ON <Fault Status>*DISABLED OFF-HOOK <Fault Status>*If the point is in fault, the display will read:FAULT OFF <Fault Status>*FAULT ON <Fault Status>*FAULT OFF-HOOK <Fault Status>**The field <Fault Status> will contain one of the device fault messages listed in Table 2.1,“Point (Device) Faults,” on page 19.Line 11 - blank.Line 12 - WALK TEST - Displays YES if the device sounds during audible Walk Test.Line 13 - SILENCEABLE - Displays YES if the operator can manually silence an activated output.The output resounds for fire.Line 14 - SWITCH INHIBIT: YES - Displays YES if the operator can not manually activate an output.Line 15 - The current time and date are displayed in this line.Line 16 - Press B A C K to return to the previous screen.3.8 General ZoneWhen a general zone address is entered into the Point Select Screen and the ACCEPT soft key ispressed, the following screen will display:Figure 3.9 General Zone Screen - Read StatusDisplayLines 1 through 7 - Refer to the descriptions in Section 3.2, “Smoke Detector”, on page 41.Line 8 - The non-resettable control setting for this zone is displayed on this line.Line 9 - The silenceable setting for this zone is displayed on this line.Line 15 - the current time and dateL A K E V I E W G E N E R A L H O S P I T A LS Y S T E M N O R M A L1 0 : 2 2 : 3 4 A T U E J A N 2 5 , 2 0 1 1R E A D A D D R E S S : N 1 2 4 Z 0 6 6A U T O M A T I C I N A C T I V E6 6 T H F L O O R Z 0 6 6N O N - R E S E T T A B L E C O N T R O L : N OS I L E N C E A B L E : N OP R E C E D E N C E P A R T I C I P A T I O N : N O1 0 : 2 2 : 3 4 A T U E J A N 2 5 , 2 0 1 1 B A C K
