Notifier AFP-3030 Operation Manual

Also see for AFP-3030: Programming manual Operation manual Installation manual Installation manual

Contents

Notifier AFP-3030 Operation Manual Manual pdf 68 page image

63 AFP-3030 Operations Manual — P/N DOC-01-039:A 26/11/2015Appendix A: Software Type ID CodesA.1 Alphabetical ListThe following chart lists AFP-3030 Type ID codes in alphabetical order. These codes are assignedduring programming based on the types and functions of the devices they are assigned. The codesappear in point message formats.Software Type ID Code DeviceABORT SWITCH Monitor that provides an abort function for a releasing zone through connection to an abortstationACK SWITCH Monitor used to silence panel sounder, and to give an acknowledge message on the paneldisplayACCL (P Sup) Acclimate detector with photo activating supervisory eventACCL+ (P Sup) Acclimate plus detector with photo activating supervisory eventAIR REF FSL-751 detector used to monitor air quality entering a protected areaALARM DEV Supervised NAC for speaker circuits.ALARM DEV FLT Monitoring audio equipment.ALARMS PEND Control module or NAC for output that will activate upon receipt of an alarm condition, andremain in the alarm state until all alarms have been acknowledged. Programmed for switchinhibitALARM TRACK Supervise protected premises for all notification and evacuation.ASPIR. (NON) For use with an aspiration detector, reports to the fire panel as a non-fire event when itsthreshold is reachedASPIR. (PRE) For use with an aspiration detector, reports to the fire panel as a prealarm condition when itsthreshold is reachedASPIR. (REF) For use with an aspiration detector, reports to the fire panel as a non-fire activation, used as areference for other aspiration detectors on the loopASPIR. (SUP) For use with an aspiration detector, reports to the fire panel as a supervisory when its thresholdis reachedASPIRATION For use with an aspiration detector, reports to the fire panel as a fire alarm when threshold isreachedAUXILIARY Control output which is used with the Auxiliary Disable buttonBELL CIRCUIT Control module used with NAC with bellsblank Operates as CONTROL with no Type ID labelCO MONITOR Monitor Module for use with conventional CO detectors. Activation will generate a CO Alarm onthe FACP.CONTROL Control module used with NACCONTROL NAC Control module or NACDBA Monitor for a Direct Brigade Access panelDOOR HOLDER Control output which is used with the Door Holder Disable buttonECS/MN MON Monitor for mass notification alarms, latchingECS/MN SUPL Monitor for mass notification supervisory inputs, latchingECS/MN SUPT Monitor for mass notification supervisory inputs, trackingECS/MN TMON Monitor used for mass notification fault inputs, trackingFIRE CONTROL Monitors non-fire activationsFMM-420 Monitors 4-20 mA industrial sensorsFORM C RESET Control module used to interrupt 24 V power to four-wire conventional detectors for 30 secondsupon reset. Used in conjunction with a monitor module with a conventional detector Type IDGEN ALARM Control module, XPC-8 circuit, or XP5-C (NAC mode) configured as a Municipal BoxTransmitter (MBT-1 required). This Type ID can also be used for general alarm activation. It isprogrammed as “switch inhibit”.GEN PEND Control module, XPC-8 circuit, or XP5-C (NAC mode) that will activate upon receipt of an alarmand/or fault condition, and remain in the ON state until all events have been acknowledgedGEN SUPERVIS Control module, XPC-8, or XP5-C (NAC mode) activated under any supervisory condition(includes sprinkler type). It is programmed as “switch inhibit”Table A.1 Software Type ID Codes, Alphabetical List (1 of 3)