Notifier CFP-600-E Installation And Operating Manual

KEYPADThe Control Panel keypad is made up of 7 keys:LED INDICATORSALARM AND TROUBLE DISPLAYALARM ACKNOWLEDGEMENTThe UPWARDS CURSOR Key allows to display, on the second and third line, all zones in alarm status, as follows:CFP-600-Prog-1.VP Installation and Operating Manual Page 1Doc. M-131.1-CFP600-ENG Rev. B.1 NOTIFIER ITALIACHANNEL 2KEY TOENABLEKEYPADBuzzer SilenceResetESC ENTERCursor Keys- ON= During Alarm- ON= During Pre-alarm- ON= General Trouble- ON= Line Trouble- ON= Mains Failure- ON= Battery Trouble- Blink.= Disab.Zone / ON=Excl. Zone- Blink.= During Walk Test- ON= During Signal Silence- ON= During Day- OFF= CPU Mains Trouble- Control Panel Power ON Signal- ON= CPU or WD TroubleEvacuation in progressRelease occuredRelease Control TroubleRelease InhibitedEvacuation in progressRelease occuredRelease Control TroubleRelease InhibitedCHANNEL 1First zone in alarm statusLast zone in alarm statusLast zone in trouble statusFirst zone in trouble statusTotal of Zones in alarm statusTotal of Zones in Trouble statusTotal of disabled ZonesA1:Z11 ALARM | A04A1:Z11 ALARM | G03FIRST FLOOR | D00T1:Z01 LINE SHORT C. | E00The second line shows the number of the zone in alarm status.The third line shows a max. 16-character programmable label,mapped to the zone.Event progressive number on alarm file Number of the zone in alarm statusEvent progressive number on trouble file Number of the zone in trouble statusSignal SilenceA1:Z11 ALARM | A04A4:Z08 ALARM | G03T3:Z04 LINE SHORT C. | D00T1:Z01 LINE SHORT C. | E00Acknowledgement is carried out when all the events on alarm file have been displayed by using the UPWARDS CUR-SOR Key. The events are displayed from the first to the last event, in chronological order.Press ESC Key to leave alarm display.N.B. : A) Reset, Control Silence and Buzzer Silence, are not allowed during alarm acknowledgement.B) Reset is allowed only after carring out all event acknowledgement.