3.2 Operations in Live View ModeIn live view mode, there are many functions provided. The functions are listed below.• Single Screen: show only one screen on the monitor.• Multi-screen: show multiple screens on the monitor simultaneously.• Auto-switch: the screen is auto switched to the next one. And you must set the dwell time for eachscreen on the configuration menu before enabling the auto-switch. Menu>Configuration>LiveView>DwellTime.• Start Recording: normal record and motion detection record are supported.• Quick Set: select the output mode to Standard, Bright, Gentle or Vivid.• Playback: play back the recorded videos for current day.• Aux/Main output switch: the DVR checks the connection of the output interfaces to define the mainand auxiliary output interfaces. The priority level for the main and aux output is HDMI>VGA>CVBS.This means if the HDMI is used, it will be the main output. If the HDMI is not used, the VGA outputwill be the main output. See the table below.Table 3. 2 Priorities of InterfacesHDMI VGA CVBS Main output Auxiliaryoutput1 √ √ √ HDMI VGA2 √ × √ HDMI CVBS3 × √ √ VGA CVBS4 × × √ CVBS √ means the interface is in use, × means the interface is out of use or the connection is invalid. Andthe HDMI, VGA and CVBScan be used at the same time.When the aux output is enabled, the main output cannot do any operation, and you can do some basic operationon the live view mode for the Aux output.3.2.1 Using the Mouse in Live ViewTable 3. 4 Mouse Operation in Live ViewName DescriptionMenu Enter the main menu of the system by right clicking the mouse.Single Screen Switch to the single full screen by choosing channel number from the dropdownlist.Multi-screen Adjust the screen layout by choosing from the dropdown list.Previous Screen Switch to the previous screen.Next Screen Switch to the next screen.Start/StopAuto-switchEnable/disable the auto-switch of the screens.NOTE The dwell time of the live view configuration must be set before using Start Auto-switch.21
