101 N V I D I A C o r p o r a t i o nC h a p t e r 8 D e v i c e S e l e c t i o n A n d C o n f i g u r a t i o nNote: The Use monitor scaling option is available for flat panels that supportmultiple native resolutions.Monitor Settings (Refresh Frequency): SecondaryDisplayNote: The Monitor Settings option only appears for the secondary displaydevice (Display 2), if the secondary device is a digital display or CRT(analog display). In this example, the secondary display device is a digitaldisplay.Follow these steps to modify the Refresh Frequency of your secondary displaydevice:Note: If you are in the nView Display Mode panel, right click the Digital FlatPanel icon and select Screen Adjustment to display the Flat PanelDisplay panel, click Monitor Settings to open the Monitor Settingspanel, then go directly to step. 4 below.1 Make sure you are in the Device Selection panel.2 Confirm that the Digital Flat Panel option is selected on the DeviceSelection panel.3 Click Device Adjustments to access the Flat Panel Display panel.4 Click Monitor Settings to open the Monitor Settings panel (Figure 8.21).Note: The Monitor Settings panel in Figure 8.21 “resembles” the Monitorpanel for your primary display (Properties > Settings > Advanced >Monitor tab) but actually represents your secondary display.The Refresh Frequency list box lists the refresh rates available for thismonitor. You may select a different refresh rate than the one that appears inthe list box. A higher refresh frequency reduces flicker on your screen.Note: It is recommend that you keep the Hide modes that this monitorcannot display option checked. Unchecking the option will allow youto set your display to modes that this monitor cannot display correctly,which may lead to an unusable display an/or damaged hardware. Also,unchecking this option will prevent enabling nView Span modes.
