OAKWORKS CFPM300 User Manual

Also see for CFLU401: User manual User manual

OAKWORKS CFPM300 User Manual Manual pdf 26 page image

DIRECTIONS FOR USEC A R B O N F I B E R A R M B O A R D (A C C E S S O R Y)CAUTION Do not place undue weight or downward pressure on the Carbon Fiber Arm Board. It is a posi-tioning device for the arms and should not be used as leverage to get on or off the table. Injurycan occur. DO NOT exceed 30 lbs. (14 kg.) of load on the Support Section. Injury can occur.UseThis radiolucent device can be used with any flat support surface where ionizing radiation (x-ray) is utilized for imaging.It can be used to support arms and feet.DirectionsUnfold the Arm Board and slide the Base Section under the patient and the table pad. Position the patient and theSupport Section to suit the needs of the procedure. The weight of the patient will hold the Arm Board in place.Rotate the Support Section to the desired position. This section rotates up to 180º.To remove the Arm Board, ask the patient to move their limb off the Support Section and lift their body slightly. Thiswill allow you to pull out the base section of the Arm Board.Fold the Base and Support sections for storage.Prone Position at 135º Supine Position at 180º Support Section Base SectionA D J U S T A B L E T-R A I L C L A M P U S E (A C C E S S O R Y)*1. The clamp must be installed only on an Oakworks®CFPM product with the groove on the underside ofthe table.2. Slide the clamp in the groove to the desired positionon the table top.3. Ensure the lower part of the clamp is aligned withand in the groove of the table top. Tighten the clampusing the handle.4. Attempt to slide the clamp. Ensure the clamp will notmove and is secured tightlghtly to the tabletop.5. The handle can be rotated without loosen up theclamp. To move the handle out of your way, lift the handle up and rotate towards the inside of thetable, then release the handle to reengage. The handle can then be used to tighten or loosen theclamp and slide to a different position on the tabeltop.Note: The Integrated T-Rails are US standard size of .38” (1cm) thick by 1.13” (3cm) wide.CAUTION Recheck tightness of T-Rail Clamp in between proceudres.Ensure that the lower part of the clamp is in the tabletop groove under the table top.Ensure the T-Rail Clamp is tight and can not move with pressure.23