OAKWORKS CFPM300 User Manual

Also see for CFLU401: User manual User manual

OAKWORKS CFPM300 User Manual Manual pdf 6 page image

WARNINGTo reduce the risk of burns, fire, electric shock or injury to persons:1. Unplug this furnishing from the electrical outlet before cleaning.2. Unplug from outlet before adding or removing parts.3. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped ordamaged, or dropped into water. Contact Oakworks Customer Service before use.4. Keep the cord away from heated surfaces.5. Never drop or insert any object into any opening.6. Do not use outdoors.7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.DANGERThe potential of exposure to harmful x-rays exists when this table is in use. The use of adequate x-ray barrierdevices is necessary to provide protection to both the operator and the patient. X-ray barrier devices are recommendedfor the patient outside of the intended target area to prevent exposure to scattered radiation from the x-ray generat-ing source.The tabletop has a typical aluminum filtration equivalence of 1.10 mm as measured at 100 kVp and a half value (HVL)of 3.6 mm. (NOTE: Bariatric Top has a typical aluminum filtration equivalence of 1.50 mm. as measured at 100 kVpand a half value (HVL) of 3.6 mm.)• Oakworks® Imaging Tables may be used for x-ray imaging where the x-ray generator is located below thetabletop and the image receptor is located above the tabletop. This is the recommended method. The tables mayalso be used for x-ray imaging where the x-ray generator is located above the tabletop and the image receptor islocated below the tabletop. This application will result in greater patient exposure to x-rays. The operator mustweigh this issue with the imaging requirements and patient exposure issues.• The Imaging Tables may be used with the x-ray generator above the tabletop and a film cassette located onthe tabletop. (See contraindications regarding film cassette size.)• The x-ray generator should never be located above the tabletop when the Oakworks® Imaging Table andthe Oakworks® Spine Positioning System/Prone Pillow are used together. This type of use requires that the x-raygenerator is located below the tabletop and the imaging intensifier or film cassette located above the tabletop.IMPORTANT SAFETY INSTRUCTIONS3