OAKWORKS CFPM300 User Manual

Also see for CFLU401: User manual User manual

OAKWORKS CFPM300 User Manual Manual pdf 4 page image

PRODUCT USE DESCRIPTION / IMPORTANT SAFETY INSTRUCTIONS1P R O D U C T U S E D E S C R I P T I O NOAKWORKS® Imaging Tables are radiographic tables intended for use with mobile or compact stationary C-armImaging Systems. It is ideally suited for pain management imaging and therapeutic procedures. These tables aresuitable to use for diagnostic x-ray imaging and imaging during therapeutic procedures such as spinal injections,vertebroplasty procedures and other pain management procedures. The CFLU and CFUR Tables are designed forLithotripsy and Urology procedures. It is intended to be operated by a healthcare professional in a medical envi-ronment. No special training is required but a review of the following Safety Instructions is important for the safe-ty of the operator and patient. The healthcare professional should read and understand this entire manual beforeuse with a patient.NOTE The EMISSIONS characteristics of this equipment make it suitable for use in industrial areas and hospitals(CISPR 11 class A). If it is used in a residential environment (for which CISPR 11 class B is normally required) thisequipment might not offer adequate protection to radio-frequency communication services. The user might need totake mitigation measures, such as relocating or re-orienting the equipment.S Y M B O L I D E N T I F I C A T I O NThis symbol, when used in this manual and on product labels, represents a caution warning. Be sure toread and comply with all precautions and warnings.This symbol, when used in this manual and on product labels, warns against an electrical shock hazard. Besure to observe and comply with all warnings.This symbol, when used in this manual and on product labels, indicates the potential of exposure to harmfulx-rays. Be sure to read and comply with all warnings.This symbol, when used in this manual and on product labels, indicates that the table and componentsare a Type B Applied Part pursuant to IEC 60601-1: 2005.This symbol, when used in this manual or on product labels, indicates a Protective Earth (Ground)Terminal.This symbol, when used in this manual or on product labels, indicates the date of manufacture of thedevice.This symbol, when used in this manual or on product labels, indicates alternating current (AC).This symbol, when used in this manual or on product labels, indicates direct current (DC).This symbol is used to indicate that the operator should consult the user manual.Sitting is prohibited in this area.~----C O N T R A I N D I C A T I O N SThe Oakworks® Imaging Tables should not be used with Imaging systems having intensifier screens or film cas-settes larger than 12 inches (30 cm) when an oblique angle of view is being used. The tables are not designed forand should not be used with Magnetic Resonance Imaging procedures.