VarioLink 5022/VarioLink 4222/VarioLink 3622 4-9Manual installation using the Add Printer wizard 4– When setting this machine for IPPS printing, enter "https:// (IP_address_of_machine) /ipp". Thewindow for confirming the user name and password appears in the course of installation.8 When the confirmation dialog box appears, click the [OK] button.9 Click the [Have Disk] button.10 Click the [Browse] button.11 Specify the desired folder on the CD-ROM that contains the printer driver, and then click the [Open]button.– Select the specified folder according to the printer driver to be used, the operating system, and thelanguage. Printer drivers that can be selected: Windows XP/Server 2003: PCL driver, PS driver– For details of the built-in CD-ROM construction, see "Contents of CD-ROM" on page 1-9.12 Click the [OK] button.The "Printer" list appears.13 Click the [Next] button.14 Follow the on-screen instructions.– If the Windows Logo Testing or Digital Signature dialog box appears, click the [Continue] or [Yes]button.15 Click the [Finish] button.16 When the installation is completed, make sure that the icon of the installed printer appears in thePrinters and Faxes window.17 Remove the CD-ROM from the CD-ROM drive.This completes the printer driver installation.Once the settings for the printer have been specified, you can use the printer in the same way as a defaultlocal printer. Also, if you set up the printer for sharing in Windows, it can be used as a network printer by otherWindows computers over the network.4.1.4 Local connectionWhen this machine is connected via a USB port, the printer driver can be installed with plug-and-play.2 NoteWhen a connection is made with the USB port, the local interface kit is required.Printer driver can be installed using the Add Printer Wizard. When using the Add Printer Wizard, selectthe USB port to be connected in the Select a Printer Port dialog box.1 Connect this machine to a computer using a USB cable, and then start up the computer.– Do not disconnect or connect the cable while the computer is starting up.2 Insert the Driver CD into the CD-ROM drive of the computer.3 Turn on the main power of this machine.The Found New Hardware Wizard dialog box appears.– If the Found New Hardware Wizard does not start up, turn off this machine, then on again.– When turning off the power, then on again, wait at least 10 seconds before turning it on again.Otherwise, this machine may not function properly.4 Select "Install from a list or specific location (Advanced)", and then click the [Next] button.– If the Windows connect to Windows Update dialog box appears, select "NO".5 From "Search for the best driver in these locations," select "Include this location in the search", andthen click the [Browse] button.
