3 Reception3-4 cm5520Reception Chapter 33.3 Manual reception (Telephone only mode)This mode should be set when an external telephone is connected and manytelephone calls are received.This mode operates when the [Receive Mode] is set to [Manual RX] in the[Line Parameter Setting] of the Utility mode.Refer to “Specifying transmission/ receiving mode (Line Parameter Settings)”on page 10-52 regarding reception mode settings.The following procedure describes operations for manual reception.Manual reception1 When the external telephone line rings, touch [Off-Hook] on the Fax/Scan screen.2 Confirm that [RX] has been selected.3 Touch the [Execute] button on the Off-Hook screen.– When [Start] key is pressed, reception starts after touching [Yes]and then touching [OK] on the “Off-Hook start” confirmationscreen.!DetailWhen reception is from a fax information service, touch [Off-Hook] andafter dialing press [Start] key.When an original is loaded in the ADF or original glass, [RX] is not high-lighted even if a fax is received.In this case, touch [RX] to highlight the button.The external phone continues ringingIncoming• Pick up the receiver and talk
